MetalworkingFun Forum

Hi Lads

I made a few steel moulding flasks for my foundry set up a few years ago ,, in the past i have always used wood flasks , these are fine , but can were out quickly ,and do burn when you have a spill .

As with nearly all of my projects they come about due to getting some free material . I scrounged a few 1/8" x 4 1/4" steel off cuts from a customer i was doing a bit work for .


First off i need to form a bead up the centre of the strips so that the sand will have something to key to , so i came up with a quick and dirty swag tool for my home built shop press .


The lengths were fead through 6" at a time to form the bead.



Next up ,, four bits of 4" steel bar were tack welded to the welding bench to form a bending fixture .


Using oxy gear the bends were heated and bent .


The overlap was then trimmed and welded.

Re bar was used for handles

Then the locating pins made and welded on .





Rob

Wow - those 4" section of steel rod put things into perspective. Nice work Rob.

(02-26-2012, 06:58 AM)Mayhem Wrote: [ -> ]Wow - those 4" section of steel rod put things into perspective. Nice work Rob.

Thanks Darren

My bad ,,, i think they may be 3"

Rob

So what are the final dimensions of those flasks Rob?

(02-26-2012, 07:16 AM)Mayhem Wrote: [ -> ]So what are the final dimensions of those flasks Rob?

I think they came out at 12" x 16" ,,,i will go measure them

Rob

Rob,

They came out rather splendid.
Nice beading, really nice piece of work.

Nicely posted as well

DaveH

Rob,

Nice job on the flasks but how did you keep the rib from going flat when you bent it?

when ever I try something like that the bead or rib as I tend to call them go's flat in the corner.

I don't see any distortion in yours at all.

Looks great!!

Jerry.

Rob,

Nice welding. How was it welding the re-bar? I was told not to bother trying to weld re-bar because it doesn't weld worth beans. I think I may have been led astray based on how good it appears to have welded for you.

Ed

(02-26-2012, 12:59 PM)EdAK Wrote: [ -> ]Rob,

Nice welding. How was it welding the re-bar? I was told not to bother trying to weld re-bar because it doesn't weld worth beans. I think I may have been led astray based on how good it appears to have welded for you.

Ed

Very nice job on the flasks they came out superb. Weldinbg rebar is ok it is just a low grade steel, the weld is usually much stronger thyan the rebar so one can't depend on the strength in a butt weld at least that's the way it was explained to me. n tom