MetalworkingFun Forum

Very nice John! It already has a nice patina that makes it look like its been around as long as your lathe.

Ed

(10-19-2012, 04:42 PM)EdK Wrote: [ -> ]Very nice John! It already has a nice patina that makes it look like its been around as long as your lathe.

Ed

Thanks Ed
Bronze tends to darken down very quickley
(i did select the best pictures as well)
John

As always - great job John. I'm looking forward to seeing you turn that screw now.

John,
Very nice job, great photo's as well.
Good job

DaveH

I must have missed this post last night somehow ?. Top notch job john
It looks spot on and will also work too , well done mate
Cheers Mick.

Hi
Lads
Made a start on the mill feed screw again
I centerd the stock 1 inch stainless
It had a run out of 15 thou in the middle (slight bend)
I set up my new steady (the steady was trailing the tool)
set up a 20 thou cut (10 ether side)
It took about half a hour to complete the cut at a nice slow speed
The bar is now straight (or the clock is broken)
The diamiter is within 1 thou over 24 inches
Now the pictures








John

Nicely done John,

DaveH

Beauty of a steady , very nicely done!

well dun john cracking job