MetalworkingFun Forum

Full Version: Kaleidoscope
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2 3 4 5 6

Bill Gruby

I did not keep track Ed but I would venture a guess at better than 100 hours. This was the hard part. Reverse Engineering is never easy. There is so much you cannot see in pictures. I call it "Guesstimation" Rotfl

"Billy G" Thumbsup
Accurate guesstimation can only be achieved when using an eyecrometer!

Looking good so far Bill. How far away from a start are you?

Bill Gruby

I like that eyecrometer. Far enough into this to start anytime Darren.

"Billy G" Thumbsup
Wow Bill, you have been busy Thumbsup Smiley-signs107
Smiley-eatdrink004
DaveH
Pages: 1 2 3 4 5 6