Lathe spindle mounted boring head.
#1
Here was a little project i made with a boring head that was given to me and i have no mill to use it on. So i adapted to to my SBL 10K's spindle. I have used it a few times but the most it gets used is when i cut the round bolt knob off of Remington 700 bolts to thread for a longer bolt knob. I made some arbors (i always make extra) and already had the long threaded shaft to hold the arbor in the spindle since i use it with #3 mt milling cutter. Enjoy...Bob


Attached Files
.jpg   n_aCAWMBF0R.jpg (Size: 32.81 KB / Downloads: 123)
.jpg   ready to run.jpg (Size: 26.61 KB / Downloads: 124)
.jpg   1.jpg (Size: 32.87 KB / Downloads: 123)
.jpg   arbors made.jpg (Size: 31.5 KB / Downloads: 124)
.jpg   boring head.jpg (Size: 33.72 KB / Downloads: 124)
.jpg   ready to thread.jpg (Size: 25.62 KB / Downloads: 124)
.jpg   spindle inside parts.jpg (Size: 34.99 KB / Downloads: 123)
.jpg   making arbors.jpg (Size: 27.38 KB / Downloads: 124)
.jpg   cutting clearance.jpg (Size: 30.55 KB / Downloads: 125)
.jpg   spindle protector wrench.jpg (Size: 33.12 KB / Downloads: 123)
.jpg   cutting rem 700 bolt.jpg (Size: 33.15 KB / Downloads: 124)
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:
#2
Bob,
Might as well mod it to make it useful, no use just sitting in a drawer. Smiley-signs107

Not too sure what you are doing in the very last photo?

Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#3
(04-10-2012, 07:15 PM)DaveH Wrote: Bob,
Might as well mod it to make it useful, no use just sitting in a drawer. Smiley-signs107

Not too sure what you are doing in the very last photo?

Smiley-eatdrink004
DaveH

Thats the next posting so i don't lose anyone :) ...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:
#4
My guess is he's "turning" something that's impossible to chuck using the boring head.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#5
(04-10-2012, 07:02 PM)aametalmaster Wrote: ... I have used it a few times but the most it gets used is when i cut the round bolt knob off of Remington 700 bolts to thread for a longer bolt knob.

Bob, I would like to see that next time you get around to doing one, if you don't mind. Popcorn
[Edit:] Oooops... I should have read further ahead in the threads. Thanks Bob!

Make up a center to put in that boring head and pop it in the tail stock for doing quick tapers. Smile
Willie
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)