+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Metrology (http://www.metalworkingfun.com/forum-33.html)
+--- Thread: Micrometer types (/thread-1057.html)
RE: Micrometer types - sasquatch - 02-10-2013
Very nice!!
RE: Micrometer types - EdK - 02-10-2013
Those boxes turned out real nice.
Ed
RE: Micrometer types - PixMan - 02-12-2013
Those sure look a lot nicer than what I shipped to you! They were SO dried out, probably why the tools weren't rusted.
It looks like you did a little clean up on those too, as they look a bit brighter.
RE: Micrometer types - Mayhem - 02-12-2013
Thanks Ken. The mics got the same treatment. Stripped down, cleaned and oiled. I plan to make a box to house all 8 mics but that may be some time away, so it was worth giving the boxes a quick spruce up.
RE: Micrometer types - Bill Gruby - 05-14-2013
As of now I finally after 25 years of trying own a Braille Micrometer.
"Billy G"
http://www.ebay.com/itm/321122913400?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649
RE: Micrometer types - Bill Gruby - 05-14-2013
I got so excited I double posted.
"Billy G"
RE: Micrometer types - stevec - 05-14-2013
Must be neat but I can't see it! (sorry, I couldn't resist)
RE: Micrometer types - Bill Gruby - 05-14-2013
Hmmm -- how bout now?
"Billy G"
RE: Micrometer types - EdK - 05-14-2013
(05-14-2013, 02:49 PM)stevec Wrote: Must be neat but I can't see it! (sorry, I couldn't resist)
You beat me to it.
Ed
RE: Micrometer types - Bill Gruby - 05-14-2013
Can you see it in the other post above???
"Billy G"