+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: a big D.T.I refit (/thread-1296.html)
Pages:
1
2
a big D.T.I refit - krv3000 - 04-07-2013
hi all i got this today it just needed my loving touch in all it is OK a part from the mane shaft so it got striped dawn in pic 3 you will see the notch cut out in the bezel to remove the retaining ring once this was out it all came a part with ease and all was given a good scrub up
RE: a big D.T.I refit - krv3000 - 04-07-2013
sos i left sum pics out
RE: a big D.T.I refit - krv3000 - 04-07-2013
once a part their was two things that needed downing one repairing the plunger rod two reaper the base cover i reaped the plunger rob by cutting the end off and drilling 1.6mm by 6 deep then taping with a m2 tap i then made a new bottom length of rod and drilled both ends 1.6mm by 6 deep then taped them m2 then with sum Bering fit and a length of m2 studding i jond the two together as for the back i just cleaned up the part that sum one had made before and silver soldered it to the back right pics
RE: a big D.T.I refit - Mayhem - 04-07-2013
RE: a big D.T.I refit - EdK - 04-07-2013
RE: a big D.T.I refit - stevec - 04-08-2013
(04-07-2013, 05:40 PM)krv3000 Wrote: in pic 3 you will see the notch cut out in the bezel to remove the retaining ring once this was out it all came a part with ease and all was given a good scrub up
( Yawn, Ho Hum)I still haven't found the "notch".
The bezel is the "glass" right?
RE: a big D.T.I refit - Mayhem - 04-08-2013
Here you go Steve:
[attachment=4960]
RE: a big D.T.I refit - stevec - 04-08-2013
Darren, is it easier to see things "down under"?
Thanx man!
RE: a big D.T.I refit - Micktoon - 04-08-2013
Hi Bob , another quality fix
, you must be able to take them things apart in your sleep now 
, I am not really a clumsy person but looking at them photos of fine springs etc I know if it was me there would not be a happy ending lol 
Keep up the good work Bob ,
Cheers Mick
RE: a big D.T.I refit - DaveH - 04-08-2013
Good one
DaveH