MetalworkingFun Forum
An Engine by 3 Amigo's - Printable Version

+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: An Engine by 3 Amigo's (/thread-1365.html)

Pages: 1 2 3 4


RE: An Engine by 3 Amigo's - krv3000 - 06-05-2013

hi before i go further i think i need to clean me bench right bored out the hole then skimmed the face off right pics


RE: An Engine by 3 Amigo's - f350ca - 06-05-2013

Nice work but I can still see lots of bench top, no where close to clean up time.


RE: An Engine by 3 Amigo's - krv3000 - 06-30-2014

hi SOS in the length of time as bi waiting for castings i went over John's IE doubleboost and him and rob was preparing to do sum casting for parts for the engine then mick turned up and we had a good time even more so when it was pointed out that John had started to develop man boobs so he got sum stick any way i came home with sum castings as not all of them turned out not enuf bronze in the pot any way i turned up the two end caps tonight and got sum pics


RE: An Engine by 3 Amigo's - doubleboost - 06-30-2014

Very nice Bob
They look like nice solid castings
I like to leave as much of the "cast finish" showing as possible
We are going to re cast the valve chest covers in "petro bond" sand this week end
John


RE: An Engine by 3 Amigo's - krv3000 - 06-30-2014

brill jhon will have to start and sort things out ? is it posibel to cast valve bodeys will av a go at making patens


RE: An Engine by 3 Amigo's - kenne - 06-30-2014

(06-05-2013, 05:46 PM)krv3000 Wrote: hi before i go further i think i need to clean me bench right bored out the hole then skimmed the face off right pics

looks normal for my shop , found a family of four living under my bench once !Rotfl


RE: An Engine by 3 Amigo's - doubleboost - 06-30-2014

It is possible
Be easier to use my mill & just machine them
(do you mean slide valves)


RE: An Engine by 3 Amigo's - Micktoon - 06-30-2014

Starting to take shape Bob, looks good bronze cast too. You will be in the shed till early hours every night now Smile

Cheers Mick


RE: An Engine by 3 Amigo's - krv3000 - 06-30-2014

no jhon the drane valves that go top and botom of the cilinders and the one on the top cuver for oiling the cilinder


RE: An Engine by 3 Amigo's - doubleboost - 06-30-2014

You make the patterns Mate
I will cast them