+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: How-To's (http://www.metalworkingfun.com/forum-8.html)
+--- Thread: Common Methods of Measuring the Diameter of a Hole (/thread-1508.html)
Pages:
1
2
RE: Common Methods of Measuring the Diameter of a Hole - TomG - 07-17-2013
(07-17-2013, 07:20 AM)Mayhem Wrote: I just have to remember not to tighten the mic up too much, as that tends to reduce the size real quick
Lol, I call that the C-clamp effect.
Thanks Darren.
Tom
RE: Common Methods of Measuring the Diameter of a Hole - DaveH - 07-17-2013
Tom,
Great video, explains it all well
DaveH
RE: Common Methods of Measuring the Diameter of a Hole - doubleboost - 07-17-2013
The use of callipers is a dying art
Very well shown & explained
John
RE: Common Methods of Measuring the Diameter of a Hole - TomG - 07-17-2013
Thanks John.
To tell you the truth, I can't remember the last time I used a pair of internal calipers, but they still worked just fine.
Tom
RE: Common Methods of Measuring the Diameter of a Hole - DaveH - 07-20-2013
I still use internal callipers ........... I suppose cause I'm old
DaveH