+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Milling Machines (http://www.metalworkingfun.com/forum-12.html)
+--- Thread: Let's See Your Mill (/thread-16.html)
RE: Let's See Your Mill - sasquatch - 11-18-2012
You took the mill through the kitchen??
RE: Let's See Your Mill - Bill Gruby - 11-18-2012
Nope, right across the rug in the living room. Piece of cake, 45 minutes start to finish. War Department was not home.
"Billy G"
RE: Let's See Your Mill - sasquatch - 11-18-2012
Thank goodness the missus was out or you would have been "Grounded " for that one!! Lol
RE: Let's See Your Mill - 4R8 - 11-18-2012
Looks like you got a good deal on that one Bill! While it's apart, it's a good opportunity for a freshen up!
RE: Let's See Your Mill - Bill Gruby - 11-19-2012
Have to replace the rubber vibration isolators on the motor mount. Had to make them, what else is new. The new ones are nylon with a rubber washer attached. To keep the nylon from snapping under tightening pressure, fender washers are used. Thr picture shows the parts and what they replace.
"Billy G"
RE: Let's See Your Mill - Rickabilly - 11-20-2012
So we're going to see some milling on the radial now ;-) I for one think you've done really well on that lil mill.
Regards
Rick
RE: Let's See Your Mill - Bill Gruby - 11-20-2012
Yes Rick, it's back to the Radial now. Been waiting for this mill for some time now. Best part is that now my mill is in the shop, no more running to the garage. Hoping to have it running by the week-end.
"Billy G"
RE: Let's See Your Mill - Mayhem - 11-20-2012
Pics Bill - we need pics!
RE: Let's See Your Mill - Bill Gruby - 11-27-2012
Before and after. I get the motor back tomorrow and electrician is also comming. Thursday it will be up and running.
"Billy G"
RE: Let's See Your Mill - Rickabilly - 11-28-2012
Lookin' good Bill