+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: How-To's (http://www.metalworkingfun.com/forum-8.html)
+--- Thread: Cutting an Internal Thread on the Atlas Lathe (/thread-1682.html)
Pages:
1
2
RE: Cutting an Internal Thread on the Atlas Lathe - Micktoon - 09-04-2013
Hi Tom,, more cracking videos
, its advice like the matter of the 30 degrees not mattering in practical terms over the 29 degrre setting that really helps people starting off. I will be interested to see if others comment on how noisey the Atlas was in back gear, it seemed loud on the video.I hope you have many more videos planned Tom, you do a good job of explaining things, thanks again Mick
If you were local I would take you for few beers , then you could blame your drinking on me
Cheers Mick