+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: Building John "Doubleboost's" ER-32 collet chuck. (/thread-1699.html)
Pages:
1
2
RE: Building John "Doubleboost's" ER-32 collet chuck. - marfaguy - 10-09-2013
After reading back through this I need to make a correction. I chucked a piece of round cold rolled steel and turned it down to just a bit more than .500" or so, THEN put the .500" ER32 collet on it and set the taper angle.
In other words you want to very slightly expand the collet before you use a dial indicator to set the cross slide angle.
RE: Building John "Doubleboost's" ER-32 collet chuck. - DaveH - 10-10-2013
That looks really nice - excellent job.
DaveH
RE: Building John "Doubleboost's" ER-32 collet chuck. - doubleboost - 10-10-2013
Looks very nice
I think you need a new DTI the one in the video must be broken
John
RE: Building John "Doubleboost's" ER-32 collet chuck. - krv3000 - 10-11-2013
well dun
RE: Building John "Doubleboost's" ER-32 collet chuck. - Micktoon - 10-11-2013
You have made a cracking job of that
, well done 
Cheers Mick