+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: a compound slide refit (/thread-1809.html)
RE: a compound slide refit - Mayhem - 11-02-2013
Nice work Bob. Good luck with the op.
RE: a compound slide refit - f350ca - 11-02-2013
Good luck with the op Bob, machining the edge of that plate with two jaws holding it isn't for the faint of heart.
RE: a compound slide refit - DaveH - 11-03-2013
Bob,
Looking good.
All the best with the op.
DaveH
RE: a compound slide refit - EdK - 11-03-2013
I hope the op goes well and wish you a speedy recovery.
Ed
RE: a compound slide refit - krv3000 - 11-03-2013
hi thank you all for your suport and best wishes did nothing to day in the workshop catch up with you all mid week all bin well
RE: a compound slide refit - stevec - 11-03-2013
Hang in and heal, bud.
RE: a compound slide refit - krv3000 - 11-08-2013
hi as back right wile i was a way i got mell the other grand dad to mill the steps in for the nuts he did this and panted it to so all i had to do was fit the bottom slide and the index ring then put the top bit back on i then had to mack 4 t bolts to fix it the the top slide SOS no pics of threading the studs i got 4 m6 bolts cut the hex head off then threaded m6 dawn to leev a 15mm collar see pic then we use thees nuts at work their m6 by 10mm square nuts they have 4 raised corners they get spot welded on to brackets well i filed the raised bits off screwed them on to the studs with sum Bering fit then cut the over hanging thread off flush then i marced up the top have of the threads and cut them off to length all dun i tuck a pi of the difrence in the two slides right pics
RE: a compound slide refit - Micktoon - 11-08-2013
Hi Bob , good to see you back in the shop mate , the compound looks spot on and the quick change tool post a nice addition too, it will be holder time next
Cheers Mick
RE: a compound slide refit - EdK - 11-08-2013
As always,
.Ed
RE: a compound slide refit - sasquatch - 11-08-2013
Again nice work Bob, and also nice pics.