+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: 32x40 H Gas Engine (/thread-2056.html)
RE: 32x40 H Gas Engine - Brian - 10-26-2014
When I cut the material for the rod I ended up with a piece just the right size for the intermediate gear.
so I set about making a No1 mod gear cutter.
[attachment=9473]
[attachment=9474]
Tested it against the lathe gear's,
[attachment=9475]
then cut a gear,
[attachment=9476]
It seems to run Ok with the lathe gear, Well we will see when the others are made.
[attachment=9477]
Well that gives me the next job
Once more in to the chips dear friends.
Brian.
RE: 32x40 H Gas Engine - DaveH - 10-26-2014
Well that is nicely done Brian
. Did you harden the gear cutter?
DaveH
RE: 32x40 H Gas Engine - Brian - 10-26-2014
Hi Dave the cutter was made from silver steel (Drill rod ) hardened and tempered. works a treat If you take light cuts.
I make clock gears with this type of cuter, it will cut a tooth in 1/8" brass at one pass, the teeth on clock gears are a lot longer the involute gears so the cutter is a little more delicate, but works just fine.
Brian.
RE: 32x40 H Gas Engine - DaveH - 10-26-2014
Thanks Brian, it looks like it worked very well
DaveH
RE: 32x40 H Gas Engine - Brian - 10-27-2014
Not a lot done today, been at the Doc's all morning.
Started on the camshaft gear
Turning the blank. I can even turn the back of the blank now after modifying the 7x12 ??
[attachment=9481]
Taking the first cut on the mill. note how blueing the edge helps.
[attachment=9482]
that's all for today
Brian
RE: 32x40 H Gas Engine - Brian - 10-28-2014
Well this is it setup on my depthing tool that I use for clock gears, it runs a treat with it's mating pair, only the crankshaft gear to do to make the set.
[attachment=9483]
Brian
RE: 32x40 H Gas Engine - Brian - 10-30-2014
The last one done.
[attachment=9486]
Yippe
Brian
RE: 32x40 H Gas Engine - dallen - 10-30-2014
how are you going to do the rings for the piston,
DA
RE: 32x40 H Gas Engine - Brian - 10-30-2014
Hi Dallen
The engine was designed from the start to take the rings from a weed cutter, so I have no problems in that respect.
Brian.
RE: 32x40 H Gas Engine - Brian - 11-04-2014
Just ordered the material for the crank --flywheels ETC.
So I will get on with the cam redesign I originally was going to make the rockers from bronze with flat cam follower but I think that the inertia of these relatively large rockers may be to great for the valve springs, so I have changed to alloy rockers with roller followers.
All well and good but the original flat followers initially lift at the tips of the cam and the rollers lift at the base circle this makes the rollers slower to respond and more affected by valve clearance.
So I have cut a cam that I think is ok and made a test rig to determine the point of initial lift so I can get the profile correct.
[attachment=9505]
Slowly slowly.
Brian