+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: [PROJECT] Spin Indexer Tailstock (/thread-2212.html)
RE: Spin Indexer Tailstock - dallen - 11-26-2014
If that's all you have, sounds like a plan.
RE: Spin Indexer Tailstock - EdK - 11-26-2014
(11-26-2014, 05:04 PM)dallen Wrote: If that's all you have, sounds like a plan.
It's not the only boring bar I have but it's the only one I'm willing to cut to length for the job.
Ed
RE: Spin Indexer Tailstock - f350ca - 11-26-2014
I don't think I've ever used the 45deg end on one of those bars, guess its to get the cutter to a shoulder. The 90 deg hole makes grinding easier for me, don't have to take the tool's angle into account. Do you not have a set of the carbide tipped boring bars, (come on) , I use them pretty much exclusively in the burring head. Cheap and cheerful Chinese but seam to hold up reasonably well.
RE: Spin Indexer Tailstock - EdK - 11-26-2014
(11-26-2014, 06:03 PM)f350ca Wrote: ... Do you not have a set of the carbide tipped boring bars, ...
I have a set but none that are even close to being long enough to bore 3.25" deep.
Ed
RE: Spin Indexer Tailstock - f350ca - 11-26-2014
I'd have to check my set, thought some were at least that long. HUM
RE: Spin Indexer Tailstock - Mayhem - 11-26-2014
(11-26-2014, 09:02 PM)f350ca Wrote: I'd have to check my set, thought some were at least that long. HUM
Same here.
RE: Spin Indexer Tailstock - stevec - 11-27-2014
My longest Chinese, carbide tipped boring bar is 4.5" from it's 3/4 Dia. shank.
But Ed, can't you slide your boring bar into your QC holder to the length you need?
Steve
RE: Spin Indexer Tailstock - EdK - 11-27-2014
(11-27-2014, 07:50 AM)stevec Wrote: My longest Chinese, carbide tipped boring bar is 4.5" from it's 3/4 Dia. shank.
But Ed, can't you slide your boring bar into your QC holder to the length you need?
Steve
Steve,
It's set up in the mill not the lathe. My boring head takes 1/2" shank tools and I haven't seen any of the carbide tipped Chinese boring tools with 1/2" shanks that will bore that deep.
Ed
RE: Spin Indexer Tailstock - Highpower - 11-27-2014
Rather than cut up your boring bar(s), maybe mill a pocket on the side of a piece of round stock and attach a carbide insert? You could make it any length and diameter you want. Just trying to think of other options you have on hand....
RE: Spin Indexer Tailstock - dallen - 11-27-2014
I have one I can loan you