+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: A lean-to (/thread-2329.html)
RE: A lean-to - EdK - 10-18-2014
Dave,
How deep are the holes?
Ed
RE: A lean-to - awemawson - 10-18-2014
Those posts ARE galvanised I trust ?
RE: A lean-to - DaveH - 10-18-2014
(10-18-2014, 12:31 PM)EdK Wrote: Dave,
How deep are the holes?
Ed
The holes are 450 x450 x450mm deep - (18" x 18" x 18" deep).
DaveH
RE: A lean-to - DaveH - 10-18-2014
(10-18-2014, 12:48 PM)awemawson Wrote: Those posts ARE galvanised I trust ?
Nah
given a coat of etch primer. DaveH
RE: A lean-to - DaveH - 10-19-2014
Concreted in the remaining two posts.
Also laid some concrete edging 'blocks'
[attachment=9417]
[attachment=9418]
[attachment=9419]
[attachment=9420]
DaveH
RE: A lean-to - DaveH - 10-19-2014
I need to allow the concrete to cure for about 5 days before I take down the supports.
Time for a rest
DaveH
RE: A lean-to - Highpower - 10-19-2014
How on earth do you keep things so neat and tidy Dave? You absolutely amaze me. If i tried something like that there would be piles of dirt, loose concrete and tools scattered everywhere!
You have a big industrial piping bag for concrete don't you?
RE: A lean-to - DaveH - 10-19-2014
I tend to clean up before I take the photo's
Also if I leave all the mess I end up falling over or fall off the step ladder
DaveH
RE: A lean-to - DaveH - 10-19-2014
(10-19-2014, 09:52 AM)Highpower Wrote: You have a big industrial piping bag for concrete don't you?
I wish
just mix a little at a time in the wheelbarrow. DaveH
RE: A lean-to - DaveH - 10-22-2014
Took the supports down, the posts didn't fall down
[attachment=9436]
[attachment=9437]
All nicely in line
[attachment=9438]
DaveH