+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: new to turning and milling! (/thread-2501.html)
new to turning and milling! - tina and the turners - 02-05-2015
hi too all, new to the game.
first little milling project... thumbs up or thumbs down?
40mmx40mm
[attachment=9993]
RE: new to turning and milling! - Highpower - 02-05-2015
Looks good to me.
Now you just need another one and then paint them appropriately.
RE: new to turning and milling! - DaveH - 02-05-2015
Looks good to me as well.
You should be pleased and proud of your achievement
DaveH
RE: new to turning and milling! - TomG - 02-05-2015
Is it loaded?
RE: new to turning and milling! - Highpower - 02-05-2015
(02-05-2015, 06:33 PM)TomG Wrote: Is it loaded?
Don't confuse this post with one of Steve's Tom.
Oh, wait..... you were talking about the DIE??
RE: new to turning and milling! - tina and the turners - 02-06-2015
thanks guys.
no TomG it isn't.... it won't be getting rolled anyway haha, i don't want to mark it!
RE: budding machinist - tina and the turners - 02-07-2015
couple of bits produced, little scuff on the pin punch 6mm shaft
RE: new to turning and milling! - schor - 02-07-2015
Just need 1 more.