MetalworkingFun Forum
Reading Digital caliper with Arduino - Printable Version

+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Metrology (http://www.metalworkingfun.com/forum-33.html)
+--- Thread: Reading Digital caliper with Arduino (/thread-2564.html)

Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16


RE: Reading Digital caliper with Arduino - chucketn - 09-28-2017

(09-28-2017, 12:12 PM)animal Wrote: tks Vinny , I was wanting to go the Arduino/ cheap caliper route . I saw that they got so far in this thread & then chuck came back with the last post . I don't know what the pull-up's resistors would do or where they would go ? I was liking what I was readin . but this Arduino stuff is all new to me . if it was a bolt or a motor I could figgure it out 
tks
animal

I eventually gave up on this. Got the Arduino to read my HF calipers, even got it to work with TouchDRO for a bit. But, there wasn't much support, and TouchDRO was too unstable on 2 different Android Tablets. A few computer/Arduino crashes and I lost the Arduino code that worked. I spent a lot of time and effort to get to the point I was at, and wasn't interested in starting over...
I still think it's doable, but I have moved on to other interests...


RE: Reading Digital caliper with Arduino - EdK - 09-28-2017

(09-28-2017, 12:12 PM)animal Wrote: but this Arduino stuff is all new to me .

Just ask and we can help. No fear of getting ridiculed here. It's not allowed.

Ed


RE: Reading Digital caliper with Arduino - Mayhem - 10-24-2017

I'm going to have to pick your brains Ed and Vinny, as I eventually want to use an Arduino to drive my dividing head. I'll start a new post once I get there. The machining stuff will not be the problem but the code will...


RE: Reading Digital caliper with Arduino - Vinny - 10-24-2017

I still need to finish mine up. There's not much left to do, just other things got in the way. Should have more time starting in January.