+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: 5 Cylinder Radial (/thread-2632.html)
RE: 5 Cylinder Radial - DaveH - 10-29-2016
Fantastic work Brian
Looks amazing 
DaveH
RE: 5 Cylinder Radial - racer-john - 11-20-2016
Beautiful workmanshift. Hope to hear it run soon.
RE: 5 Cylinder Radial - Brian - 01-12-2017
Have had a lot of bad weather over the past two months. six and a half inches of rain in 12 hours caused land slides in the town
and on the mountain roads and then snow.
The shop was just to cold for me so I spent my time doing another slide show. you have seen most of it apart from the tapping part. other than that I have been tucked up in the warm practising my ukulele.
Still waiting to get a good gear cutter.
Brian
RE: 5 Cylinder Radial - krv3000 - 01-12-2017
Fantastic work Brian
RE: 5 Cylinder Radial - TomG - 01-12-2017
Hey Brian,
I was just wondering what you have been up to.
Thanks for sharing the slide show. It's definitely starting to look like a legitimate radial.
Tom
RE: 5 Cylinder Radial - pepi - 01-13-2017
Brian,
I have a two descriptive words for that OUTRAGEOUS and RIGHTEOUS. That is an extreme build, feel very lucky for having the pleasure of seeing it come together.
Thank you
Greg
RE: 5 Cylinder Radial - Brian - 02-04-2017
At last the replacement cutter has arrived. I have made a test piece so tomorrow I will make the test gear.
Keep fingers crossed.
[attachment=14197]
Brian
RE: 5 Cylinder Radial - TomG - 02-05-2017
Hopefully they took the time to mark this one correctly.
Tom
RE: 5 Cylinder Radial - Bill Gruby - 02-05-2017
Many times people have bought from ebay only to find the sets, 1 thru 8 marked in reverse order.. The problem is ongoing with lots of complaints.
"Billy G"
RE: 5 Cylinder Radial - Brian - 02-06-2017
This one is marked as number 4 but 21- 25 tooth so what do we believe ??
Made a hash of the test yesterday My fault something moved during the last cut
and I cant find what. Very annoying, good job it was only the test piece.
Brian