+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: 5 Cylinder Radial (/thread-2632.html)
RE: 5 Cylinder Radial - Brian - 05-08-2021
Well its almost ready to go. only needs a non return valve in the oil tank and a drop of fuel.
so keep fingers crossed.
[attachment=16997]
Brian
RE: 5 Cylinder Radial - Vinny - 05-08-2021
Lookin forward to it!!!
RE: 5 Cylinder Radial - Brian - 08-09-2021
After a lot of fiddling with the mixture and going over valve and ignition timing. IT RUNS the mixture requires further attention and the oil system jet has to be smaller. but it has no vibration after all my fears about that.
Run time is 30 mins in two sessions.
[attachment=17258]
[attachment=17259]
[attachment=17260]
Yee Harr.Brian.
RE: 5 Cylinder Radial - TomG - 08-09-2021
Congratulations, Brian!
Can't wait to see the video.
Tom
RE: 5 Cylinder Radial - Vinny - 08-09-2021
YAY!!!!
RE: 5 Cylinder Radial - Hawkeye - 08-09-2021
It's a thing of beauty, Brian. Great work!
RE: 5 Cylinder Radial - Pete O - 08-10-2021
(08-09-2021, 06:09 PM)TomG Wrote: Congratulations, Brian!
Can't wait to see the video.
Tom
X2!
RE: 5 Cylinder Radial - Dr Stan - 08-10-2021
That looks like a wonderful project once I get set up in Manila.
RE: 5 Cylinder Radial - Brian - 08-10-2021
One video coming up https://youtu.be/57J0WQEjbCc 6 years of work !!!
Brian.
RE: 5 Cylinder Radial - Pete O - 08-15-2021
A great result Brian. Just so you know, about 10 of the video views so far are me :)
Looking forward to the dyno results...