+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Milling Machines (http://www.metalworkingfun.com/forum-12.html)
+--- Thread: Setting Up My PM935 Mill (/thread-2981.html)
RE: Setting Up My PM935 Mill - Dr Stan - 05-09-2016
(05-09-2016, 06:46 PM)EdK Wrote: Sad news for Darren. This thread has almost run its course.
I predict only about ten more pages.
Ed
Oh I'll bet you could stretch it out to 100 if so desired.
RE: Setting Up My PM935 Mill - Vinny - 05-09-2016
Congrats Ed!!! Unless it's really still in the garage and you just put a pic of the basement backdrop behind it...
RE: Setting Up My PM935 Mill - Pete O - 05-10-2016
Congratulations Ed, patience and perseverance has paid off, now you know every nut and bolt of the machine and it's probably in better shape than when it left the factory. We'll want to see chips before page 60.
RE: Setting Up My PM935 Mill - Mayhem - 05-10-2016
Congratulations Ed - I can lock the thread now that you're done if you like. I've not had the opportunity to do that yet
RE: Setting Up My PM935 Mill - pepi - 05-10-2016
(05-05-2016, 05:32 PM)Rob.Mueller Wrote: Ed, Is the warranty on your mill expired yet?
OTFLMAO.... I have been thinking the exact same thing.... but held back cause I am a boot yet.
RE: Setting Up My PM935 Mill - PixMan - 05-10-2016
Chips or it never happened!
RE: Setting Up My PM935 Mill - rleete - 05-10-2016
(05-09-2016, 06:46 PM)EdK Wrote: Sad news for Darren. This thread has almost run its course.
I predict only about ten more pages.
Ed
I think it needs to move half a foot to the right...
RE: Setting Up My PM935 Mill - Dr Stan - 05-10-2016
(05-10-2016, 11:20 AM)rleete Wrote:(05-09-2016, 06:46 PM)EdK Wrote: Sad news for Darren. This thread has almost run its course.
I predict only about ten more pages.
Ed
I think it needs to move half a foot to the right...
One piece at a time.
RE: Setting Up My PM935 Mill - EdK - 05-10-2016
(05-10-2016, 03:15 AM)Pete O Wrote: now you know every nut and bolt of the machine
That's not far from the truth. I measured every fastener and wrote down where they went. I'm writing a manual for the mill and wanted as much detail as possible.
Ed
RE: Setting Up My PM935 Mill - EdK - 05-10-2016
(05-10-2016, 11:20 AM)rleete Wrote: I think it needs to move half a foot to the right...
Oh hell no! Not going to happen.
Ed