+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: How-To's (http://www.metalworkingfun.com/forum-8.html)
+--- Thread: Ball Turning, on a horizontal mill (/thread-3003.html)
Ball Turning, on a horizontal mill - Sunset Machine - 12-20-2015
I should get points off for this, but not wanting to disturb lathe setups I used a horiz mill, lathe-like. A chuck on the spindle, a home-made arbor support being used as a steady rest, a rotary table and a vice to hold the toolbit. Just tossing out ideas for those with these mills.
RE: Ball Turning, on a horizontal mill - Roadracer_Al - 12-25-2015
NICE!
RE: Ball Turning, on a horizontal mill - Highpower - 12-25-2015
That's thinking outside the box. I like it!!!
RE: Ball Turning, on a horizontal mill - TomG - 12-26-2015
That's a new one on me. Way to use the ole noggin.
Tom