+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Gunsmithing (http://www.metalworkingfun.com/forum-27.html)
+--- Thread: Spectre1995's Remington Model 6 (/thread-3034.html)
Spectre1995's Remington Model 6 - spectre1995 - 01-07-2016
Hello everyone, I'm new here and thought I might share a little project I've been working on over the past couple months. I noticed the names of a few of you here are also members of the Weapons Guild, to which I am also a member, so you probably have seen this all already.
While the project is nearly finished, there is still some work that has to be done to it. It's a scratch made, bolt together version of the Remington Model 6. I don't have access to a mill and lathe, so a majority of this project was made using a drill press, an angle grinder, a hacksaw, and hand files. Eventually I want to get a decent mill, but right now I need a better welder.
RE: Spectre1995's Remington Model 6 - Highpower - 01-07-2016
Welcome to the forum spectre.
That certainly shows some determination on your part using minimal tooling.
What material did you use for your build?
RE: Spectre1995's Remington Model 6 - spectre1995 - 01-07-2016
The mid-section and internals are all 4140, but the side plates are 1018.
RE: Spectre1995's Remington Model 6 - EdK - 01-07-2016
Nice work spectre. Oh and
to the forum.Ed