+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Hard turning on a knee mill. (/thread-3538.html)
Hard turning on a knee mill. - Viperspit - 04-23-2017
Has any one out there tried hard turning in a mill? If so, what inserts do you like best and what technique do you use? Here is a YouTube video showing the inserts and technique I use. Hard Turning on a Acer Mill - YouTube
Steve
RE: Hard turning on a knee mill. - EdK - 04-23-2017
Nice tip Steve.
Ed