+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Milling Machines (http://www.metalworkingfun.com/forum-12.html)
+---- Forum: Mill Tooling (http://www.metalworkingfun.com/forum-20.html)
+---- Thread: Vise Sizing (/thread-3561.html)
Pages:
1
2
Vise Sizing - the penguin - 05-05-2017
The in coming Rockwell mill, has a 6-1/2" x 24" table, looking for a good milling vise. I have 6" on the other 2 mills (a Jet JVM 836 and the infamous Franken-Mill), wonder on the best size for the Rockwell?? 4"?? or 5"?? or some other size.
RE: Vise Sizing - wawoodman - 05-05-2017
I have a 5" Glacern on mine.
RE: Vise Sizing - Vinny - 05-05-2017
I have a 5x24 table on mine and use a 4" screwless vise on it.
RE: Vise Sizing - EdK - 05-05-2017
I recently got a 4" vise for my mill. I've got a 6" Kurt vise but I can't lift it off the mill table without risk of injury so I got the 4" for the projects that don't need the capacity of the Kurt vise. Most of my projects don't need the 6" vise. Here's the link to the 4" vise I got from Precision Matthews.
4" Vise
I'm very happy with the vise. I ran a DTI across the fixed jaw and got less run-out than the Kurt vise has. Actually, I got no detectable run-out.
Ed
RE: Vise Sizing - Mayhem - 05-05-2017
(05-05-2017, 07:12 PM)EdK Wrote: ...Actually, I got no detectable run-out...
You did make sure the indicator tip was touching the jaw, didn't you?
RE: Vise Sizing - EdK - 05-05-2017
(05-05-2017, 07:45 PM)Mayhem Wrote:(05-05-2017, 07:12 PM)EdK Wrote: ...Actually, I got no detectable run-out...
You did make sure the indicator tip was touching the jaw, didn't you?
Yes. I couldn't believe it at first but ran the test a number of times.
Ed
RE: Vise Sizing - Mike E. - 05-06-2017
The most suitable vise I have for my mill's 6" x 32" table is a 4 1/2" Jones and Shipman model. Here are a couple of photos, with one alongside my 6" vise for comparison.
RE: Vise Sizing - Mayhem - 05-06-2017
Don't underestimate the bonus of the added mass of a larger vise.
RE: Vise Sizing - Mike E. - 05-06-2017
Most of the mass of my 6" vise hangs over the edge of the table, gets even worse when the jaws are opened.
RE: Vise Sizing - EdK - 05-06-2017
(05-06-2017, 10:47 AM)Mayhem Wrote: Don't underestimate the bonus of the added mass of a larger vise.
That's a very good point Darren. I use the Kurt vise when I need to do some serious hogging of metal no matter how small the piece I'm working on is.
Ed