+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Lathes (http://www.metalworkingfun.com/forum-11.html)
+--- Thread: [HELP] What's mt taper? (/thread-3589.html)
Pages:
1
2
RE: What's mt taper? - texx - 06-06-2017
link to a thread in another forum with some info .
http://chaski.org/homemachinist/viewtopic.php?t=48749
RE: What's mt taper? - f350ca - 06-06-2017
Do you need to use the taper? My Summit has a #6 MT, came with a sleeve to #5 but I've never used it. When I want to turn between centres I chuck a piece of scrap and cut a 60 deg point on it. Zero runout then.
RE: What's mt taper? - Andy T - 06-07-2017
(06-06-2017, 06:06 PM)f350ca Wrote: Do you need to use the taper? My Summit has a #6 MT, came with a sleeve to #5 but I've never used it. When I want between centres I chuck a piece of scrap and cut a 60 deg point on it. Zero runout then.
At this time I don't need to use the taper but the between centers distance is only around 12" so at some time an "every little helps" situation may arrise and I'd rather figure a solution now than leave it to a possible last minute suituation.
While searching Google for an answer I came across this pdf that has a vast amount of info but sadly none for me, http://cnqzu.com/library/Anarchy%20Folder/Workshop/Machining%20and%20Machinery/Machinery%27s%20Handbook%20(27.8)/26663_yg8.pdf
RE: What's mt taper? - Mayhem - 06-07-2017
What is the tailstock taper?
My old lathe had a 3" through hole with some form of taper that (like Greg's lathe) would have had an adaptor to make it useful. Like Greg, I've always just turned a piece of scrap to a taper when turning between centres.
RE: What's mt taper? - f350ca - 06-07-2017
My lathe must have an odd taper too. The manual lists the headstock taper as #6, but has a 3 inch through hole. According to the chart you posted the inside of the bushing must be #6.
RE: What's mt taper? - Andy T - 06-07-2017
(06-07-2017, 07:23 AM)Mayhem Wrote: What is the tailstock taper?
My old lathe had a 3" through hole with some form of taper that (like Greg's lathe) would have had an adaptor to make it useful. Like Greg, I've always just turned a piece of scrap to a taper when turning between centres.
It's a MT2, and I've now bored it through to 10mm so I can knock the tapers out.
I had to bore the minor dia a little deeper to 14mm to allow tapers with tangs, all's fine with the tailstock now
RE: What's mt taper? - Mayhem - 06-07-2017
Ah - yes! I remember now. At least one end is sorted!