Small tool post quick change for your lathe. - Printable Version +- MetalworkingFun Forum (http://www.metalworkingfun.com) +-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html) +--- Forum: Lathes (http://www.metalworkingfun.com/forum-11.html) +---- Forum: Lathe Tooling (http://www.metalworkingfun.com/forum-19.html) +---- Thread: Small tool post quick change for your lathe. (/thread-4235.html) Pages:
1
2
|
Small tool post quick change for your lathe. - Doc55 - 09-14-2020 [attachment=16773] Here is the drawing for a tool post quick change I designed up and made for my lathe a long time ago. Here is the drawing. RE: Small tool post quick change for your lathe. - EdK - 09-14-2020 Is that your own design? Ed RE: Small tool post quick change for your lathe. - Doc55 - 09-14-2020 (09-14-2020, 05:56 PM)EdK Wrote: Is that your own design? Yes I did this back in 2008 and I shared it once before not sure of the date a long time ago. ps LOL I looked at my files I actually did that long before 2008 The original was done in pencil then around 2008 I did it in cad as a practice project. Man how time fly's. RE: Small tool post quick change for your lathe. - Dr Stan - 09-15-2020 Looks like a very good design. I'm just not needing a new tool post. RE: Small tool post quick change for your lathe. - TomG - 09-15-2020 Looks good. Did you build one? Tom RE: Small tool post quick change for your lathe. - Doc55 - 09-15-2020 I've built a few over the years some went to friends I have one on my lathe. The way they load tools give them great repeatedly and usually repeat well within .0005 so working with more than 1 tool is no problem. They are well worth building for your lathe. RE: Small tool post quick change for your lathe. - EdK - 09-15-2020 What CAD program did you use to draw it? Ed RE: Small tool post quick change for your lathe. - Doc55 - 09-15-2020 It was done while I was employed I used Unigraphics which is now NX.While employed I also used Solidworks and also used Catia RE: Small tool post quick change for your lathe. - EdK - 09-15-2020 Could you post some pictures of it on your lathe? I'll be purchasing a small lathe in the near future and this looks like it may be a good fit for it. Thanks, Ed RE: Small tool post quick change for your lathe. - Doc55 - 09-15-2020 I'll try and get some photos tomorrow and post. It is shown in a lot of my videos channel is doc0455 |