+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: Holt Engine (maybe) (/thread-4268.html)
Pages:
1
2
RE: Holt Engine (maybe) - Highpower - 02-13-2021
Looks like that thing is going to be a brute!
RE: Holt Engine (maybe) - haroldmulder - 02-13-2021
Very nice. Technically I can figure out where the seam should be based on the screw heads but visually lot harder to see.
Very good work.
Harold
RE: Holt Engine (maybe) - f350ca - 02-13-2021
Thanks Harold,
I added two 1/8 dowel pins to locate the halves, The sides were machined after assembly, but the ends mated up after machining each piece.
RE: Holt Engine (maybe) - Highpower - 02-13-2021
(02-13-2021, 08:28 AM)haroldmulder Wrote: Very nice. Technically I can figure out where the seam should be based on the screw heads but visually lot harder to see.
Very good work.
Harold
I agree. At first glance it all appeared to be a single block (no pun intended) of aluminum until I noticed the screw heads. That is quite a fit!