+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: Pulley Puller Adapter (/thread-4333.html)
Pages:
1
2
RE: Pulley Puller Adapter - Dr Stan - 07-22-2021
The Webb lathes I had when teaching at the vo-tech did not have the necessary markings to set the compound to 29.5 degrees. I had the students use a combination square protractor head to set the compound. It was a good exercise to teach them there were multiple ways to achieve the correct results.