+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: 1st Engine: PM Research 2A engine (/thread-502.html)
1st Engine: PM Research 2A engine - lazylathe - 06-18-2012
Hi Guys!
I finally finished my first project!
A PM Research 2A wobbler.
Not too bad for a first project and it only took me a week to do it!
I did not take any during pictures...
It is simple and enough have been built!
I still need to disassemble it and paint it but that will be done when time permits.
The good news it... IT RUNS!!!!!
Anyway here is a very short clip taken with my iphone.
Once it is complete i will do a better one!
http://youtu.be/ShCiVHDcxD0
Andrew
RE: 1st Engine: PM Research 2A engine - EdK - 06-18-2012
Andrew,
That sounds like it's running very nicely. Nice job.
Ed
RE: 1st Engine: PM Research 2A engine - Bill Gruby - 06-18-2012
Way cool, I like it Andrew.
"Billy G"
RE: 1st Engine: PM Research 2A engine - DaveH - 06-18-2012
Andrew,
Very nice
DaveH
RE: 1st Engine: PM Research 2A engine - doubleboost - 06-18-2012
Andrew,
Very nice
Great to see a fly wheel with no wobble
John
RE: 1st Engine: PM Research 2A engine - krv3000 - 06-18-2012
hi and a good job well dun
RE: 1st Engine: PM Research 2A engine - TomG - 06-19-2012
Good job Andrew. It looks to be a nice smooth running engine.
Congrats on your first!
Tom
RE: 1st Engine: PM Research 2A engine - ETC57 - 06-19-2012
Looks great Andrew,
Jerry.
