+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Gunsmithing (http://www.metalworkingfun.com/forum-27.html)
+--- Thread: Machining an AR15 lower receiver (/thread-520.html)
RE: Machining an AR15 lower receiver - d65 - 11-30-2013
Very impressive ! I wish I had your machining skills! I just finished an 80% AR Lower in cast aluminum and I thought I did a good job. In my defense, this was my first project on my new cheapo Grizzly mini mill. Never have used a mill or lathe before. You however, look like you may have been at this awhile!!! I love the learning curve.
RE: Machining an AR15 lower receiver - stevec - 12-01-2013
(06-20-2012, 04:48 PM)doubleboost Wrote: If we start playing with guns we will get locked up.Same here in Canukistan, John.
John
Steve
RE: Machining an AR15 lower receiver - Highpower - 12-22-2013
(11-30-2013, 09:49 PM)d65 Wrote: Very impressive ! I wish I had your machining skills! I just finished an 80% AR Lower in cast aluminum and I thought I did a good job. In my defense, this was my first project on my new cheapo Grizzly mini mill. Never have used a mill or lathe before. You however, look like you may have been at this awhile!!! I love the learning curve.
I would love to see some pictures of your finished receiver.
Mine was a first effort on my cheapo Enco mill, so you aren't alone.
