MetalworkingFun Forum
Storage Building - Printable Version

+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: Storage Building (/thread-547.html)

Pages: 1 2 3 4 5 6 7 8 9 10


RE: Storage Building - Rickabilly - 07-16-2012

(07-16-2012, 07:29 PM)f350ca Wrote: Still too hot here for this cowboy, but managed to get the trusses built. Now to stand them up. Going to be interesting, I don't have an end wall to easily brace the first one to.
Ahh, Now I've played this game before,
the first truss goes up in the middle! rather than bracing the top of the truss to an end as you normally would when building a roof, what you do is knock a 2x4 into the ground directly below that first middle truss and bind the 1st truss to this upright, after the ends of the truss are secured to the beams at each end that first truss will be very secure, and you can brace the following trusses to it easily.

I hope this helps.
Best Regards
Rick


RE: Storage Building - ETC57 - 07-17-2012

Greg,
How about welding a temporary support to one of the sea cans? Smile
Jerry.Popcorn


RE: Storage Building - Rickabilly - 07-17-2012

If you're not to worried about affecting corrosion resistance or future value of the "sea cans" I'd weld that support on and leave it there, why not?
or even through bolt a simple bracket and brace to that, to seal it later just put a silicone covered bolt through the hole!

Best regards
Rick


RE: Storage Building - f350ca - 07-17-2012

All great suggestions, but I just got brave and nailed the bottom of the truss to the blocking and hoped the first two didn't fall over till I could brace them to each other. Slow work off the scaffolding (home made by the way) over the open section but have 1/3 of them up at the end of the day. Was getting dark hence the poor phone photo quality.

[Image: IMG_0084.jpg]


RE: Storage Building - Rickabilly - 07-18-2012

Wow Greg, that is actually looking pretty good, My Dad had planned to do something similsr before he passed away and I tried to talk him out of it assuming it'd look pretty rough and very "improvised" but it looks quite respectable now that the trusses are going up, I suppose they take away the "Boxy" look.
Best Regards
Rick


RE: Storage Building - Mayhem - 07-18-2012

Nice work. To be honest, I was expecting a flat roof, not a gabled one. I guess geographical location has a lot to do with that though. So where are the hot tub and the bar going Greg?


RE: Storage Building - DaveH - 07-18-2012

Greg,
Ooow that does look good Smiley-signs107
DaveH


RE: Storage Building - krv3000 - 07-18-2012

i think i need him to billed me a new workshop


RE: Storage Building - ScrapMetal - 07-18-2012

A thought just crossed my mind (short trip, right? Rolleyes ), if you haven't already, plan on putting some gutters across both the front and back of the roof. You'll really want to get that water away from the building.

-Ron


RE: Storage Building - sasquatch - 07-18-2012

Looking great!! Always changes things a lot when one finally gets the trusses up.

Is this going to be strapped and a metal roof?