MetalworkingFun Forum
P&W 1830 Radial in 1/6 scale. - Printable Version

+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: P&W 1830 Radial in 1/6 scale. (/thread-573.html)

Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30


RE: P&W 1830 Radial in 1/6 scale. - Mayhem - 05-01-2013

Wow - they will be something to behold. Do these use counterweights?


RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-01-2013

There are two ways to accomplish this Darren. One is Hall Effect and the other a Mechanical type. I am going Mechanical.

"Billy G"


RE: P&W 1830 Radial in 1/6 scale. - Mayhem - 05-01-2013

less to go wrong that way!

Is ignition timing used to 'throttle' these engines Bill?


RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-01-2013

The Timing is involved Darren, but not all the time. It still uses the Carb.

"Billy G"


RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-02-2013

Breaker Arms are up first. They are all mill work and the most tedious part. That is the print for them and the two brass blanks.

"Billy G"


RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-07-2013

Got some shop time today. The little lady was up and about most of the day. Thank you all for your concerns.

OK we left off at starting the guts of the distributor. Here are two pics. #1 it the rough blanks anf the rough holding fixture. Pic #2 is the matched blanks to the finished fixture. Should be done with these in the mill tomorrow.

"Billy G"


RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-08-2013

This type of machining with small end mills can get to you in a hurry. I got 3 holes and the inside shape done today. That's it. That small brass pin in pic #2 is my stop.

"Billy G"


RE: P&W 1830 Radial in 1/6 scale. - EdK - 05-08-2013

(05-08-2013, 05:44 PM)Bill Gruby Wrote: ... I got 3 holes and the inside shape done today. That's it.
"Billy G"

Billy,

That's three more holes than I got done today.

Ed


RE: P&W 1830 Radial in 1/6 scale. - Bill Gruby - 05-09-2013

Back at it, the ID is finished now working on the OD.

"Billy G"


RE: P&W 1830 Radial in 1/6 scale. - Mayhem - 05-09-2013

I'm watching with interest Bill...