+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: Another puller (/thread-603.html)
Another puller - Mayhem - 07-08-2012
I need to replace the bearings in the motor for my mill. The pulley was well and truly stuck onto the shaft and the motor diameter exceeded the limits of my press. So into the scrap bin, a couple of welds, the pressure screw (borrowed) from another puller and a few nuts, bolts and washers:
[attachment=2296]
[attachment=2297]
[attachment=2298]
RE: Another puller - doubleboost - 07-08-2012
Propper job
John
RE: Another puller - DaveH - 07-08-2012
Mayhem,
Well done
DaveH
RE: Another puller - Mayhem - 07-08-2012
Thanks guys - one of the easier jobs I have done lately. I may have to get a bigger box to put my 'special' pullers in. One I have is about 1m long.
RE: Another puller - Highpower - 07-08-2012
Improvise, adapt, and overcome. Outstanding!
Willie
RE: Another puller - ETC57 - 07-08-2012
Well done,
Jerry.
RE: Another puller - Mayhem - 07-09-2012
Thanks guys.
For those of you who are still scared of your welder, the same result could have been achieved using angle iron for all the components.