Steel Crucible
#11
Good point
The shop was well ventilated (double doors open)
I was looking towards the humorous side of things.
On reflection i see how my comment about warming the shop up could have been taken seriously
It would not bother me (in fact i would be happy) for you to edit my post accordingly
John
Reply
Thanks given by:
#12
John,
Nice job. Smiley-signs107 Smile

What I would like to know is, why are the first welds done with MIG, and finished with a "stick" welder. I can see with the "stick" there is more weld, so can't a MIG welder put a large weld down?

Now for the second question, why not use "stick' for all the welds?

Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#13
(04-15-2012, 11:37 AM)doubleboost Wrote: It would not bother me (in fact i would be happy) for you to edit my post accordingly
John

John,

Just an FYI.
You have 24 hours from the time you post a message to edit it. After that, a moderator would need to do any editing.

Ed
Reply
Thanks given by:
#14
Thanks for that
Ed
John
Reply
Thanks given by:
#15
(04-15-2012, 12:56 PM)DaveH Wrote: John,
Nice job. Smiley-signs107 Smile

What I would like to know is, why are the first welds done with MIG, and finished with a "stick" welder. I can see with the "stick" there is more weld, so can't a MIG welder put a large weld down?

Now for the second question, why not use "stick' for all the welds?

Smiley-eatdrink004
DaveH

Hi
Dave
I just fancied doing some welding
The first weld is with TIG
Then a run of MIG
I could have just stick welded the hole job
But with a TIG root weld you know the job will be good
My mig welder is a bit underpowerd for steel that thick
Basically i was just playing with my weldersBig GrinBig GrinBig GrinBig Grin
John
Reply
Thanks given by:
#16
Is that ALL you did today Popcorn

Rob Tongue
Reply
Thanks given by:
#17
No
Mate i had some dinner as well
John
Reply
Thanks given by:
#18
ha ha ha i will let you off then Big Grin

Rob
Reply
Thanks given by:
#19
John,
What metal will you be melting in this steel crucible?
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#20
(04-15-2012, 02:33 PM)DaveH Wrote: John,
What metal will you be melting in this steel crucible?
Smiley-eatdrink004
DaveH

It will be used for aluminium
I have ceramic crucibles but not one this size i have melted bronze in steel crucibles before
But now i use ceramic ones
You get better heat transfer
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)