Setting Up My PM935 Mill
(11-07-2015, 08:29 PM)Mayhem Wrote:
(11-07-2015, 08:25 PM)wrustle Wrote: Come on Ed, step it up a bit will ya! We're getting impatient!  Big Grin

Says the man who's signature should read "to be continued..." Big Grin

Rotfl
Reply
Thanks given by:
yea Russ when you going to finish the tall tale about the turret lathe Big Grin Big Grin
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
Not much to show but got the 50 feet of 10 gauge wire strung from the mill area to the sub panel. Also removed the 20A breaker and installed the 30A breaker and got the 10 gauge wire hooked up to it. In the process, I had to remove the wiring for the lathe from the sub panel so now I have no power to any of my machinery.

Ed

   
Reply
Thanks given by:
I must say, I do enjoy wiring.  Hopefully you will have power back to everything soon and without any mishaps 
.gif   electrocute.gif (Size: 10.12 KB / Downloads: 111)
Hunting American dentists since 2015.
Reply
Thanks given by: EdK
A previous post mentioned conduit and that's all I used in my shop.  Excellent accessibility for modifications.  Since I did all the labor I went with 10 ga for virtually all my wiring except for the 10Hp 120 gallon air compressor and the Miller MIG using 8 for those applications. Must be the little bit of German ancestry showing itself.
Reply
Thanks given by:
Stan, we think alot alike. When we rebuilt the garage into a shop (lower level) and office (upper level) all electrical was done in conduit. The arc welder outlet I recently put in was done with #6. Everything else ('cuze nothing really draws enough to even need #10) was done with #12 stranded. I ran a number of circuits with a feeder from the house to a sub panel out here.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
Conduit here too. Finished the walls first and then laid the pipe, running #12. If I have to go #10 later, just use the #12 to pull it in with. No problem at all to add/move lighting and outlets. Dunno about inside the house though, it wouldn't seem right to run conduit. My garage is an "industrial" setting, different.
Reply
Thanks given by:
In my office upstairs, the conduit was put in before the drywall went up.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
Are we talking steel or plastic conduit?
Smiley-eatdrink004 
DaveH
 a child of the 60's and 50's and a bit of the 40's Smile
Reply
Thanks given by:
I'm talking no conduit.

Anyway, I was hoping to have a quite birthday in the shop but the family would have nothing of that. I did steal enough time to get the lathe wired in with a fused disconnect so I at least have one machine I can play with.  Smiley-dancenana

Ed

   
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)