11-07-2015, 08:51 PM
Setting Up My PM935 Mill
|
11-08-2015, 04:34 PM
yea Russ when you going to finish the tall tale about the turret lathe
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
11-14-2015, 04:18 PM
Not much to show but got the 50 feet of 10 gauge wire strung from the mill area to the sub panel. Also removed the 20A breaker and installed the 30A breaker and got the 10 gauge wire hooked up to it. In the process, I had to remove the wiring for the lathe from the sub panel so now I have no power to any of my machinery.
Ed
11-14-2015, 06:12 PM
I must say, I do enjoy wiring. Hopefully you will have power back to everything soon and without any mishaps
electrocute.gif (Size: 10.12 KB / Downloads: 111)
Hunting American dentists since 2015.
Thanks given by: EdK
11-14-2015, 10:45 PM
A previous post mentioned conduit and that's all I used in my shop. Excellent accessibility for modifications. Since I did all the labor I went with 10 ga for virtually all my wiring except for the 10Hp 120 gallon air compressor and the Miller MIG using 8 for those applications. Must be the little bit of German ancestry showing itself.
11-14-2015, 11:00 PM
Stan, we think alot alike. When we rebuilt the garage into a shop (lower level) and office (upper level) all electrical was done in conduit. The arc welder outlet I recently put in was done with #6. Everything else ('cuze nothing really draws enough to even need #10) was done with #12 stranded. I ran a number of circuits with a feeder from the house to a sub panel out here.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique
11-15-2015, 09:03 AM
Conduit here too. Finished the walls first and then laid the pipe, running #12. If I have to go #10 later, just use the #12 to pull it in with. No problem at all to add/move lighting and outlets. Dunno about inside the house though, it wouldn't seem right to run conduit. My garage is an "industrial" setting, different.
11-15-2015, 01:57 PM
In my office upstairs, the conduit was put in before the drywall went up.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique |
« Next Oldest | Next Newest »
|
Users browsing this thread: 14 Guest(s)