03-18-2016, 05:28 PM
Setting Up My PM935 Mill
|
03-18-2016, 06:37 PM
I see no reason why it shouldn't Ed.
Hunting American dentists since 2015.
Thanks given by: EdK
Thanks given by: EdK
03-19-2016, 01:01 AM
Ya forgot the duck tape. Every Southern Engineer "knows" everything works better with duck tape.
Oh, that's right you're in Minnesota. Never mind.
03-19-2016, 09:09 AM
That's actually quite a bit of overkill. You should be able to lift your car with that setup.
Full of ideas, but slow to produce parts
03-19-2016, 11:50 AM
03-19-2016, 03:32 PM
Finally some progress with the mother ship. Got it safely off of the pallet and onto the floor. I thought the front end was going to dip much more than it did. It sits solidly on the floor with no rocking at all and if does the same when I get it down into the basement I don't think I'll need any levelling feet. It looks like it might be at the ideal height for my short stature.
I was surprised that the mounting holes were tapped. I thought they would be just through holes. They must be metric since they're larger than 5/8 and a 3/4 bolt doesn't fit the threads. It must be 19mm. Tomorrow I'll attempt to get it on its back on the sled. Ed
04-17-2016, 07:36 AM
Anything further since we last saw the base lying on its "sled"?
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 58 Guest(s)