Setting Up My PM935 Mill
(05-09-2016, 06:46 PM)EdK Wrote: Sad news for Darren. This thread has almost run its course.

I predict only about ten more pages. Sad

Ed

Oh I'll bet you could stretch it out to 100 if so desired.   Smiley-signs107
Reply
Thanks given by:
Congrats Ed!!! Unless it's really still in the garage and you just put a pic of the basement backdrop behind it...
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
Congratulations Ed, patience and perseverance has paid off, now you know every nut and bolt of the machine and it's probably in better shape than when it left the factory. We'll want to see chips before page 60.
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by:
Congratulations Ed - I can lock the thread now that you're done if you like. I've not had the opportunity to do that yet Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by: EdK
(05-05-2016, 05:32 PM)Rob.Mueller Wrote: Ed, Is the warranty on your mill expired yet?  Slaphead

OTFLMAO.... I have been thinking the exact same thing.... but held back cause I am a boot yet. Smiley-eatdrink004
Magazines have issues, everything else has problems

Reply
Thanks given by:
Chips or it never happened!

Big Grin
Reply
Thanks given by:
(05-09-2016, 06:46 PM)EdK Wrote: Sad news for Darren. This thread has almost run its course.

I predict only about ten more pages. Sad

Ed

I think it needs to move half a foot to the right...
Full of ideas, but slow to produce parts
Reply
Thanks given by:
(05-10-2016, 11:20 AM)rleete Wrote:
(05-09-2016, 06:46 PM)EdK Wrote: Sad news for Darren. This thread has almost run its course.

I predict only about ten more pages. Sad

Ed

I think it needs to move half a foot to the right...

One piece at a time.   Thumbsup
Reply
Thanks given by:
(05-10-2016, 03:15 AM)Pete O Wrote: now you know every nut and bolt of the machine

That's not far from the truth. I measured every fastener and wrote down where they went. I'm writing a manual for the mill and wanted as much detail as possible.

Ed
Reply
Thanks given by:
(05-10-2016, 11:20 AM)rleete Wrote: I think it needs to move half a foot to the right...

Oh hell no! Not going to happen. 5176

Ed
Reply
Thanks given by:




Users browsing this thread: 8 Guest(s)