Minimal Clockmaking
#61
Nice workmanship Brian. Even with all the hand work, it still looks "machine made" (compliment intended). Thumbsup

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#62
(01-15-2013, 11:30 AM)TomG Wrote: Nice workmanship Brian. Even with all the hand work, it still looks "machine made" (compliment intended). Thumbsup

Tom

Thanks Tom from you, thats a real compliment.
Just to keep things ticking over while i wait (forever) for a no57 drill. this is the first part to go together .
   

Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
#63
Nice work Brian , thanks for these interesting postings.
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:
#64
Yep,
Very interesting Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#65
Just made the baby Top Hat bushes that are required because I am using steel plates.

   

Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
#66
Had to take time off for rebuilding the boat engine. but storms have got in the way ,so it's into the shop again.
Made the main arbor and did a trial assy.

   

Coming on Smile Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
#67
Hi Brian,
Is it fixed to that shaft?
They are tiny little screws - what size are they?
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#68
Hey Somethings going wrong I just realized this is the first time that I did the drawing then made the part?? Not like me at all ,must be getting ill or worse still, old ,
I think I need a lie down 17428

Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
#69
Hi Dave
The gear will be fixed but the ratchet is free .

The screws are 8 BA the smallest on this clock will be 10BA,

Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by: DaveH
#70
" more photos , This time of the plates with the bushings fitted.
   

   
the taper broach is used to enlarge the bushes until the arbor fits.

Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)