Minimal Clockmaking
Some real nice work going on hear DroolDroolDroolDrool
All a bit small for my clumsy fingers and weary eyesJawdropJawdrop
John
Reply
Thanks given by:
It's a thing of beauty Brian. I like the look of the cycloidal tooth profile. It's very...clock like.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
Its running on the test stand, with a Foliot from another clock.

   

It will stay on test to run it in while other parts are made.

Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
nice to see it coming together
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
Next job is to get the motion work set up, first the gears are put on the depthing tool, to get them running at the same centres, this measurement will be transferd to the front plate, to place the min wheel stud.

The --minute wheel pipe -- hour wheel pipe --and hour wheel collet all run co axial on the stud.

   

When this is done its on to the dial.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
Coming along nicely.

   

BrianSmile
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
Dial posts and feet made.

   

Brian
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
Nice work as always Brian. Thumbsup

Ed
Reply
Thanks given by:
Whilst I don't really know what I am looking at in many of these posts, I'm enjoying the thread and looking forward to see the finished product. Then I may be able to figure it out?

Nice work Brian.
Hunting American dentists since 2015.
Reply
Thanks given by:
I'm with Mayhem Chin
Looking good though
Smiley-eatdrink004
DaveH
Reply
Thanks given by:




Users browsing this thread: 4 Guest(s)