I have been in my shop see
#1
    I hope to do a better job of documenting my work on the second one.Smiley-signs081

But as you can see I've not been completely idle, this is one of two hood vents to be mounted on ether side of the hood of my 76 Ford pu to help get rid of engine heat.

This one still needs some clean up on the mill and a quick polish but all and all I'm quite happy:shy:

Jerry.Popcorn[attachment=173]            

And I still need to figure out how to put pics in my post the way I want them!!! Chin


Attached Files Thumbnail(s)
   
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#2
Jerry,

That's looks good, is it Ali?Smiley-signs107

I bet drilling all those little holes was a bit of a pain.Chin
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#3
Hi Dave,

thank youBig Grin

No stainless and the screen pre drilled.

Boy what an education!!

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#4
Jerry
You have done a nice job, I like the way the inside edges are rounded.
Smiley-signs107
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#5
Good job ETC, I was a little puzzled with the first pic, but the finished product looks great!
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#6
Nicely done
A totall one off
John
Reply
Thanks given by:
#7
Nice work Jerry.
Hunting American dentists since 2015.
Reply
Thanks given by:
#8
Thank you all, when I start the second one I'll get pics of set up and operation, I got so involved with the first one I forgot to take picsSmiley-signs081

Jerry.Slaphead
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#9
Smiley-signs107 Top Job Jerry

Very nice Drool


Rob
Reply
Thanks given by:
#10
(03-07-2012, 12:03 PM)RobWilson Wrote: Smiley-signs107 Top Job Jerry

Very nice Drool


Rob

Thank you Rob.:shy:

Jerry.Popcorn

ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)