Fire Wood Processor
put a battery on it and see if it will start
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
That's nice! You could put a 2 output gear box on it and have a splitter & a generator. :)
Reply
Thanks given by:
Stripped off the generator, actually had to to get it out of the enclosure.
Its been sitting for 20+ years, rolling the flywheel over at first indicated no compression, but after a few revolutions Im getting it on one cylinder. May give it a drink of atf through the intake and see what happens. Could well be stuck valves. The hour meter is only showing 582 hours.
[Image: IMG_2056.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
That is one nice freebie Greg. looks like the same engine as my Kubota lawnmower, although I'm sure they come in various displacement / horsepower sizes. Mine has the hydrostatic gearbox drive from one end of the crank and the PTO for the deck off the other end via twin B-section v belts.
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by:
While the engine marinates in ATF Im working on the transfer case. This is the driven shaft, it will drive the one hydraulic pump and the electric clutch. I need to cut a keyway down that 1:4 taper, any ideas how to hold the shaft?

[Image: IMG_2059.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
3 jaw chuck or collet in a a fixture on an angle? Me? I'd cheat and try to hold the shaft in the vise with a spacer under it to hold the angle and go for it.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
The vice idea was what I was planning Vinny then I remembered I'd built a tooling plate and have never used it. Worked like a charm. Almost a sine plate.
[Image: IMG_2061.jpg]

The finished product.

[Image: IMG_2065.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
Nice!!!
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by: f350ca
Very nice setup. I'll have to remember that. I'll have to build a tooling plate first... I do have a tapping head, and if I could ever figure out what size the J-Flex collets are, I'd order some bigger sizes.
Reply
Thanks given by:
Would sure like to have a tapping head, you can't imagine how much when I was making that plate. Saw it on a machining video, possibly OX Tool, he was using it with a pivot and stops to radius the ends of linkages. Worked really nice, but now I can't remember what I was going to make the linkages for.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:




Users browsing this thread: 9 Guest(s)