Fire Wood Processor
(04-02-2016, 11:46 PM)Mayhem Wrote: One thing that is not lost on me however, is the quality of Greg's work and his capacity to progress through so many projects.

Two words... Not - Human.

He can't be. He gets more done in a day than I can get done in a year! Worthy
Willie
Reply
Thanks given by:
I have never seen a vise like you have mounted on your shaper. Very good idea.
Reply
Thanks given by:
Been doing lots of little bits that aren't worth posting. Wiring the engine, building throttle and shut down linkages etc.
With a box of fittings in hand we started running pipe today. Takes a while to get your head around where they need to run to avoid the next one and what direction to make the bend (yah had to cut a couple of bends off) . One end is flared but the ends at the valve had to be silver soldered on, the valve is too small for the flare nuts to clear each other.
[Image: IMG_2129.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
(04-15-2016, 09:05 PM)f350ca Wrote: Been doing lots of little bits that aren't worth posting. Wiring the engine, building throttle and shut down linkages etc.
With a box of fittings in hand we started running pipe today. Takes a while to get your head around where they need to run to avoid the next one and what direction to make the bend (yah had to cut a couple of bends off) . One end is flared but the ends at the valve had to be silver soldered on, the valve is too small for the flare nuts to clear each other.

Those steel pipes are going to help a lot with cooling the oil. I was getting ready to start hammering on you again about not posting your progress.

Looks really professional so far. Great job.
Reply
Thanks given by:
Much better than hose would, you see a lot of equipment thats all hose then add an oil cooler. Plus the tubing was free and the flared ends are a lot cheaper than the crimp on hose ends.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
(04-03-2016, 07:52 AM)Pete O Wrote: I gotta get me a shaper- I have been making arbor spacers for the U2 mill when I get the chance (which is seldom) and the keyways have taken me a couple of hours each. Although somehow I feel that the gap between Greg's work and my work is more than just owning a shaper...

How 'bout a keyway broach?  If you have a arbor press (preferred) or a hydraulic press you can use a broach.
Reply
Thanks given by:
Starting to look like a pot of spaghetti,

[Image: IMG_2150.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
Mmmmmmmm...... spaghetti... Drool
Willie
Reply
Thanks given by:
(04-18-2016, 05:12 PM)Highpower Wrote: Mmmmmmmm...... spaghetti...   Drool

+1 Drool

Ed
Reply
Thanks given by:
no HydraZorb clamps?
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)