Dividing Head
#1
Hi
Lads
I am going to build a dividing head
As described in
The Amateur's Lathe
by
L.H.Sparey

I will be doing some video as I well
Made a start on the pattern for the base
This is slightly larger than the one on the book as my Boxford has a higher centre height ,than the Myford 7 it was originally built for
[Image: IMG_4951_zps1b63c7fe.jpg]

[Image: IMG_4950_zps5e14b158.jpg]

[Image: IMG_4948_zpsae4917ab.jpg]


[Image: IMG_4956_zpsb0e672cc.jpg]

[Image: IMG_4954_zpsaac31c9a.jpg]

John
Reply
Thanks given by:
#2
This is going to be interesting Thumbsup
Good book by the way
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#3
Drool Sign0087 Popcorn

Ed
Reply
Thanks given by:
#4
[Image: intriguingdog.jpg]
Willie
Reply
Thanks given by:
#5
EEEEYUP gonna follow this one all the way.

"Billy G"
Reply
Thanks given by:
#6
as per john brill
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#7
Just got through watching part 2. Very interesting. I plan on paying very close attention.
John, the wax stuff you use to make fillets with. If you don't mine me asking, what's it called?
If it's crazy but it works, it's not crazy.
Reply
Thanks given by:
#8
(07-24-2013, 03:22 PM)marfaguy Wrote: Just got through watching part 2. Very interesting. I plan on paying very close attention.
John, the wax stuff you use to make fillets with. If you don't mine me asking, what's it called?

Hi
It is called fillet wax
I think it is beeswax
John
Reply
Thanks given by:
#9
(07-24-2013, 03:22 PM)marfaguy Wrote: Just got through watching part 2. Very interesting. I plan on paying very close attention.
John, the wax stuff you use to make fillets with. If you don't mine me asking, what's it called?

Part 2 ? Did I miss a post with a video part?

"Billy G"
Reply
Thanks given by:
#10
Bill,
Part one's here
http://www.youtube.com/watch?v=YKwwMGba8wU
If it's crazy but it works, it's not crazy.
Reply
Thanks given by:




Users browsing this thread: