Log Splitter
More welding questions.

The end cap thickness is 3mm the same thickness as the tank. Now what if I used 6mm or 10mm thick steel for the end caps would that be a bad idea.
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:
Nop, just weld hotter and direct the arc toward the heavier section.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
Thanks Greg.
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:
At the moment I'm finishing off the base for the pusher, I'd already started thinking the 25mm thick steel would have been here last week.

Just 3 bits and a few holes for the nuts and bolts to hold it together.

   



I'll finish the base first then I'll start welding again. Chin Big Grin
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:
The base part more or less finished, still have to clean it up a little. Still waiting for the 25mm stuff.

   

Smiley-eatdrink004
DaveH
Reply
Thanks given by:
It's starting to look like something now Dave. Thumbsup

Ed
Reply
Thanks given by:
Does seem to be taking a long time, all this stop and start plus losing bits doesn't help. Big Grin 
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:
Shop Monster is constantly hiding my stuff where I can't find it.

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
(03-16-2015, 04:09 PM)dallen Wrote: Shop Monster is constantly hiding my stuff where I can't find it.

DA

Rotfl

However I'm still ticked off about the 25mm steel that seemed to have 'walked' off.
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
(03-16-2015, 04:12 PM)DaveH Wrote:
(03-16-2015, 04:09 PM)dallen Wrote: Shop Monster is constantly hiding my stuff where I can't find it.

DA

Rotfl

However I'm still ticked off about the 25mm steel that seemed to have 'walked' off.
Smiley-eatdrink004
DaveH

only thing I can say is you will find it exactly where you laid it down at.

same place I finally found the drive dog for my wood lathe, now if I could just find where I put the dead center I could turn that piece of rosewood I want to make a cleaning rod handle out of

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:




Users browsing this thread: 8 Guest(s)