Clamp Type Knurling Tool
#41
That's a nice looking cutter. Thanks for posting
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
#42
(11-30-2014, 02:27 PM)dallen Wrote: know a guy that made one, hope you like cutting some really small gears.

I've never cut a gear so I guess it's better to screw up a bunch of small gears rather than large ones.  Smile

dallen Wrote:Will be watching for the thread.

DA

I wouldn't hold my breath waiting. It'll likely be next summer before I tackle that one. It's a very involved project so will be a good challenge.

Sorry to hijack your thread Tom. Blush

Ed
Reply
Thanks given by:
#43
Tom,

I was wondering if there's an error in the drawing for the knurl holder? You list dimensions for the dowel holes as .250 +.000/-.001 thru and the other one as .250 +.001/-.001 to slot. I was wondering if the to slot should be .250 +.001/-.000?

Thanks,
Ed
Reply
Thanks given by:
#44
Hmmm, I thought I had that fixed, but it's fixed now.

Thanks for pointing it out Ed.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by: EdK




Users browsing this thread: 1 Guest(s)