Browning A-Bolt III
#31
Thanks Mike. Maybe once they are anodized.
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#32
Tom, how did you do the bores on your rings? Individually, line-bored in situ, reamed or lapped? Just curious. I do like the choice of the 30mm tube too. Smiley-eatdrink004
Willie
Reply
Thanks given by:
#33
Willie,

I bore them with the caps on in the same set-up. I may check the fit on the tube with some Prussian blue and if necessary take a thou or two off the parting surfaces and lap them. Although I suspect that won't be necessary.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by: Highpower




Users browsing this thread: 1 Guest(s)