Leveling?
#21
Wong, sounds like a plan! Carefull on the edges with a carbide tool in the router and you're good to go.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#22
(09-24-2012, 05:38 PM)Wongster Wrote: I was hoping that my wife agrees to the change of the kitchen top to Corian. The cut out portion for the stove would be about right for the lathe or the mill.

Funny you should say that, my supplier for the little pieces I use is a local kitchen and bathroom guy that always has a load of cutout sections from sinks and cook tops as well as the normal offcuts.

Maybe you can look up a local kitchen guy?

Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)