mill head to table align'
#11
I always put 1-2-3 blocks on the table and tram the head to them. That way the indicator tip doesn't have go over the T-slots. I use a co-axial indicator holder to be able to sweep a wide area.
Reply
Thanks given by:
#12
go to the parts store and get yourself a cheap brake rotor that is big enough to cover the table and use that to run the indicator on
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)