5 Cylinder Radial
Well its almost ready to go.  only needs a non return valve in the oil tank  and a drop of fuel. 
so keep fingers crossed.

   

Brian  Smiley-dancenana
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
Lookin forward to it!!!
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
After a lot of fiddling with the mixture and going over valve and ignition timing. IT  RUNS     the mixture requires further attention and the oil  system jet has to be smaller. but it has no vibration  after all my fears about that.

 Run time  is 30 mins in two sessions.


.jpg   run 1.JPG (Size: 614.07 KB / Downloads: 7)

   

   

Smiley-dancenanaYee Harr.

Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
Congratulations, Brian! Thumbsup

Can't wait to see the video.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
Thumbsup YAY!!!!
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
It's a thing of beauty, Brian. Great work!
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:
(08-09-2021, 06:09 PM)TomG Wrote: Congratulations, Brian! Thumbsup

Can't wait to see the video.

Tom

X2!
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by:
That looks like a wonderful project once I get set up in Manila.
Reply
Thanks given by:
One video coming up https://youtu.be/57J0WQEjbCc 6 years of work !!!
Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
A great result Brian. Just so you know, about 10 of the video views so far are me :)
Looking forward to the dyno results...
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)